Product Center
Product Center
Current Location:Home > Product Center > Product > Alu. E-Cap

Aluminum Electrolytic Capacitors

4166com金沙澳门金沙娱乐场2015.comjsa6038金沙娱乐


QUICK GUIDE TO ALU. E-CAP. USAGE 



金沙js777


ATTENTIONS TO ALU. E-CAP. USAGE

 

Circuit Design

1Polarity

Regular electrolytic capacitor has polarities. Reversing voltage causes short circuit breakage of the capacitor or leakage of electrolyte. Thereforea bipolar capacitor should be used where the polarity in a circuit is reversed or unknown.

2Over-voltage

Do not overload voltage continuously. Leakage current increases drastically when voltage is overloaded to the capacitors.

3Operating temperature and Life time

Do not use the capacitor over the maximum operating temperature. Life time of capacitor depends on its operating temperature. Generally, life time is doubled per10℃decrease.

4Explosion-proof Vent

It is recommended at least3mmof space around the vent. If such space is not provided, the vent will not operate completely.

 

5Ripple Current

Do not apply a ripple current exceeding the rated maximum ripple current. Apply too much ripple current to the capacitor causes great heat generation, invites deterioration of properties of canes breakage. Please consult factory if ripple current exceeds the specified limit.

 

6Charge and discharge

Frequent and quick charge/discharge generates heat inside the capacitor. This will cause increase of leakage current, decrease of capacitance, or breakage occasionally. Please consult us for assistance in this application.

7、-jsa6038金沙娱乐Tangent of loss angle increases at higher frequencies-4166com金沙

The tangent of loss angle (Tanδ) increases as the applied frequency becomes higher whereas decreases as the ambient temperature become higher.

 

8Capacitance decreases at higher frequencies

    The capacitance value is measuredat 120Hz.-金沙js777

The capacitance decreases as the applied frequency becomes higher whereas increases as the ambient temperature become higher.

9 Sleeve insulated

The sleeve of Aluminum Electrolytic Capacitors is not recognized as an insulatorand therefore the standard Capacitors should not be used in a place where insulation functions is needed

 

10 Capacitors assembling environment

Do not locate any wiring and circuit patterns at the assembling position of the capacitors;Do not design a circuit that heat generating components are arround the Capacitor;

 

Assembling capacitors.

1Assembling

(1)         Electrolytic Capacitors cannot be recycled after Mounting and applying electricity in unit;

(2)         Capacitors may accumulate charge naturally during storage. In this case,discharge it with a resistor of 1KΩ;

(3)         Leakage current of capacitors may be increased durin storage.In this case, the capacitors should be subject to voltage treatment through a resistor of 1KΩ;

(4)         Ensure capacitors polarity and specified capacitance and voltage before mounting;

(5)         Do not use a capacitor which has been dropped onto a hard surface;

(6)         Donot use a capacitor which damaged or dented cases or seals;-澳门金沙娱乐场2015.com

(7)         Pitch between lead and lead of capacitor must match the distance between hole and hole on the PCB;

(8)         Avoid excessive force when clinching lead wire during autoinsertion process.

2Soldering

Improper soldering temperature/time may shrink or break the insulating sleeve and/or damage the internal element as terminals and lead wires conduct heat into the capacitor. So please avoid too high soldering temperature and/or too long soldering time.



Typical failure modes and factors of aluminum electrolytic capacitors